CARBON KOREA 2026 Preview: LFT-LCF Materials At Booth 3 in Seoul

CARBON KOREA 2026 at a Glance

From November 4 to 6, 2026, CARBON KOREA 2026 will take place at COEX Magok in Seoul, South Korea. Our LFT-LCF materials will be on display at Booth 3, at the booth of Target Aerospace Korea.

This page is a preview, published ahead of the show so that buyers can plan their visit in advance. Because our materials are shown at a partner booth rather than at a stand under our own company name, visitors should look for Target Aerospace Korea at Booth 3. That distinction matters for planning: the fastest way to find the materials is to go directly to Booth 3, rather than searching the hall for our company name, and to note the grade names on display for a follow-up conversation after the show.

What Will Be on Display

Long carbon fiber thermoplastics (LFT-LCF) are designed for mission-critical structures. They combine long carbon fibers with a thermoplastic matrix for metal replacement, weight reduction and dimensional stability, with the long fibers forming a reinforcing network.

The display will include PA6+LCF50 and PP+LCF30.

• Superior metal replacement
• Exceptional dimensional stability
• A range of matrices including polyamide, PPA and PEEK

The display is a starting point, not a specification sheet. The right grade depends on the part, its loads, and its service conditions, so use the grades on display to narrow the conversation, then discuss sampling and further options with us directly.

Visitors should also note that the display shows material grades, not finished customer products, so the value is in the material itself and in how it can be applied to a new part, rather than in a single ready-made component.

Who It's For

The grades on display are intended for buyers working on structural and mission-critical parts, including:

• Robotics
• UAV and aerial equipment
• High-performance structural parts

To judge fit quickly, think about what the part must do, what it replaces today, and what has limited the current material. A large or load-bearing part, where weight and dimensional accuracy are both critical, is worth bringing to the conversation. A small, lightly loaded part with no performance problem today is less likely to need this grade.

It also helps to know what your current material cannot do, whether that is strength, heat resistance, fatigue, or dimensional stability, because that gap is often what decides whether a long carbon fiber grade is worth evaluating.

If your part is large, load-bearing, or must perform reliably under demanding conditions, Booth 3 is a useful place to start the conversation - and if it is not, the display will make that clear quickly as well.

See the Materials at Booth 3

Our team will not attend in person. The materials will be on display at Booth 3, hosted by Target Aerospace Korea. Visitors can see LFT-LCF grades and brochures from November 4 to 6.

If you are not attending, please contact us via our contact page or by email to discuss brochures, grades and sampling.

After the show, the same route remains open. If you noted a grade name at Booth 3, mention it when you contact us, together with a short description of your part and what it must do. That helps us continue from the display, rather than starting again from a general inquiry.

When you contact us, it helps to include your current material, your target performance, and a short description of the part, so the conversation can start from your requirements rather than from a general grade list.

Xiamen LFT Composite Plastic Co., Ltd. manufactures long fiber thermoplastic (LFT) compounds, including LFT-LCF grades, for sampling and mass production.