1. Crystallized material, low hygroscopicity, easy to melt fracture, long-term contact with hot metal is easy to decompose.
2. Good fluidity, but the shrinkage range and shrinkage value are large, and shrinkage, dent and deformation are easy to occur.
3. The cooling rate is fast, the pouring system and the cooling system should be slowly dissipated, and the molding temperature should be controlled. The direction of the material is low and the direction is obvious. The low temperature and high pressure are especially obvious. When the mold temperature is lower than 50 degrees, the plastic parts are not smooth and easy to weld. Bad, leaving marks, warping deformation is easy to occur above 90 degrees
4. The plastic wall thickness should be uniform to avoid lack of glue and sharp corners to prevent stress concentration.
Easy to decompose under certain conditions
Please feel free to contact us if you have any problems.
Xiamen LFT Composite Plastic Co.,Ltd
Candy Hu
Email: candyhu@lfrtplastic.com
Tel : 0086-186-5906-9962 (wechat/whatsapp)
Skype:candy328520
Address : No. 27,Hongxi Road, Ma xiang town, Xiang 'an district, Xiamen(361000),China
